SIMPLIS Analysis Modes - Overview

SIMPLIS offers three analysis modes:

To setup a SIMPLIS simulation, you must first set the schematic editor to SIMPLIS mode by doing the following:

  • From the menu bar, select Simulator > Choose Analysis....
    Result: The following dialog appears from which you choose and configure the analysis that you want to use.

As with SIMetrix, you can also enter the "raw" netlist command in the F11 window. The contents of this window remain synchronised with the "Choose Analysis dialog box" settings so that you can freely switch between the two methods. For more information on SIMPLIS analysis modes including details of the netlist commands, see the SIMPLIS Reference (Help > Online Manuals > SIMPLIS Simulator Reference Manual).

  1. SIMPLIS Transient Analysis
  2. Periodic Operating Point
  3. POP Advanced Options
  4. SIMPLIS AC Analysis
  5. SIMPLIS Simulation Options
  6. SIMPLIS Multi-step Runs - Overview
  7. SIMPLIS Initial Condition Back Annotation
  8. SIMPLIS Data Selection - Overview
Collected links
SIMPLIS Transient Analysis
Periodic Operating Point
AC Analysis
SIMPLIS Reference