The trace command is used to set up a simulation trace while a simulation is running. To set up a trace before a simulation is started, use the .TRACE or .GRAPH simulator controls.
Trace signal-name trace-id
|
signal-name |
Net name or pin name for voltage or current to be traced. |
|
trave-id |
Integer value used to group traces together on the same graph. All traces with the same trace-id will go to the same graph. |
Traces set up with this command only remain in effect until the end of the simulation. A Trace command executed before a simulation starts will have no effect.
| ▲ Command Summary ▲ | ||
| ◄ TitleSchem | Undo ▶ | |